Cookiename	Beispielinhalt	Ablaufzeit
_ga_*	deleted	730 Tage
_ga	GA1.1.8643343795.1726666186	730 Tage

3D-basics TPM Wash Solvent 20 L

SKU: ACAP-1014-003

3D-basics TPM Wash Solvent is a non-flammable, low-odor solvent designed for cleaning and dissolving uncured resin from parts 3D-printed using stereolithography (SLA).

Weight (Please select): 5 L 5 L
20 L 20 L
10 L 10 L

376,19 €

18,81 € per 1 l

incl. 19% VAT ,

Goods ordered. expected on 16.10.2026.*

Delivery time: 7 - 9 Workdays
(DE - int. shipments may differ)

3D-basics TPM Wash Solvent 20 L

376,19 €

18,81 € per 1 l

incl. 19% VAT ,

Fast shipping

13+ years experience

Secure payment

PayPal Plus Visa Apple Google Klarna Visa Mastercard Billie Vorkasse

Description
Contact

3D-basics TPM Wash Solvent - available from IGO3D

TPM Wash Solvent (tripropylene glycol monomethyl ether) is a non-flammable, low-odor solvent designed for cleaning and dissolving uncured resin on stereolithography (SLA) 3D-printed parts. TPM has a lower evaporation rate than IPA, and you can wash approximately three times as many parts with TPM as with IPA before it needs to be replaced.

TPM is not currently certified for use with Formlabs’ biocompatible resins.

TPM is compatible with Formlabs’ Finish Kit, Form Wash, and Form Cure.

Usage

Always wear gloves when handling TPM.

To remove uncured resin from SLA or DLP-printed parts, fill your cleaning vessel with the amount specified by the manufacturer. To minimize waste, it is recommended to pre-clean the parts before placing them in the cleaning tank to extend the life of your fresh TPM. This can be done in a separate container with "dirty" TPM from previous cleaning cycles or low-evaporation cleaners such as DPM, TPM, or PGDA. Place the finished print in the cleaning vessel and clean the parts for at least 5 minutes or according to the material manufacturer’s guidelines. After the cleaning cycle, rinse the TPM-coated part with water, let the model dry, and check for a sticky surface; repeat if necessary until the surface is no longer sticky. If it is still sticky, replace the TPM.

Item information	Value

Others also bought:

Formlabs Form 3 Resin Pump

213,01 € *

Formlabs Form 4 Resin Tank

141,61 € *

Formlabs Form 4 Mixer

59,50 € *